Program 2008 bmw key fob6/7/2023 Apparently there's some sort of time lock!! - I didn't! I'm way to impatient the most i managed was 5 and i was back out again! Basically if you turn the ignition again it restarts the process. I read somewhere that you have to wait 15 minutes before trying it again if your key stops working when it goes wrong. I followed steps 5 - 8 straight after the locks jumped and hey presto 2 working remotes!! JOY!!! the locks will jump for each key that is done successfully. finally release the unlock button and the locks should jump up and down to show its worked! now you have to press the lock button 3 times but each time you have to press and hold for a count of 1 then release.Ĩ. Held the key over my left shoulder (near the steering wheel didn't work for me)ħ. After about 3 seconds i took the key out of the ignition.ĥ. Put the key in the ignition turned it until all of the lights came on but not the starter.Ĥ. I used a key that didn't work.( it did before is started playing about with this but technically it wasn't working)ģ. Sat in the car and I left the doors open as normalĢ. Anyway this the method that worked for me ġ. It all Got kind of hairy at one point because nothing i tried worked. However, using then as a perfect guide i managed to figured it out (with some trial and error). It didn't work for me following the instructions above exactly. These instructions are for programming a new key when you do not have a working key fob. Thought i'd post the results of my key tests. Again the doors should lock and unlock, and youre done.
0 Comments
Leave a Reply. |